PROCEDURE TO RUN H F O PURIFIER

PROCEDURE TO RUN  H F O PURIFIER

1.      CHECK GEAR OIL  LEVEL.

2.      OPEN SUCTION &DISCHARGE V/V

3.      OPEN 5 HV-165HV-11&PUMP INTERCONNECTION V/V ON DISCHARGE SIDE FOR PURIFIER NO 1,

4.      CHECK EPC 30 PRO GRAMME

5.      MAKE SURE PROGRAMME SWITCH IS IN STOP POSITION.

6.      CHECK MARST 1 CONTROL UNIT

7.      CHANGE OVER SWITCH FROM OFF TO STANDBY POSITION.

8.      WAIT 120 SEC(until 000 appear)

9.      START PURIFIER.

10.  START OIL FEED PUMP.

11.  OPEN INLET  &OUTLET V/V OF OIL HEATER , DON’T FORGET TO CHECK AGAIN WHEATHER IT SHOWS SETTING TEMPERATURE.

12.  TURN EPC 30  UNIT SWITCH TO POSITION RUN.

13.  (WHITE LAMP OPERATION &YELLOW LAMP DISCHARGE WILL SHOW)

14.  WHEN DISCHARGE REG LAMP GOES OFF , START MARST 1 UNIT FROM STANDBY TO ON POSITION.

PROGRAMME TO STOP PURIFIER

1. TURN SWITCH TO STOP POSITION ON EPC 30 UNIT.
2. WHITE OPERATION LAMP WILL OFF; YELLOW DISCHARGE LAMP WILL START FLASHING.
3. SWITCH OFF MARST 1 UNIT (WHITE LAMP WILL GOES OFF).
4. AFTER 20 SEC ,YELLOW DISCHARGE LAMP BECOME STANDBY LIGHT.
5. RETURN MARST 1 UNIT TO STANDBY POSITION.
6. PURIFIER WILL STOP AUTOMATICALLY WITHIN 3 MIN.
7. MAKE SURE PURIFIER COME TO  STANDSTILL.

      

  DRAIN THE BOWL

1. MAKE SURE TO RELEASE THE BRAKE IF IT WAS ON.
2. START THE PURIFIER MANUALLY ON THE MOTOR STARTER &RUN FOR A MINUTE IN ORDER  TO EMPTY THE BOWL.DON’T USE THE PROGRAMME SWITCH.
3. OFF EPC 30 UNIT.